04/29/2021 Setting up Your Timebase and Using Memory Correctly

Setting up Your Timebase and Using Memory Correctly

Oscilloscope Coffee Break Webinar Series

Date: Thu, April 29, 2021
Time: 11AM Pacific | 2PM Eastern
Duration: 30 minutes

 

Register Here 

 

Setting up Your Timebase and Using Memory Correctly Webinar

Join Teledyne LeCroy for this 30-minute Oscilloscope Coffee Break Series to remind us how to get the most test and debug capability from our oscilloscopes. Grab your refreshment and spend a few minutes with us as we focus on a specific topic each month.

We are all pretty good at setting a time window for our capture. But, what about the waveform memory that is used for the capture? How does this interact with the sample rate as we vary the time window? Can we segment the timebase to capture only the important circuit behaviors?

Topics to be included:

  • Timebase, memory length and sampling rate – how do these impact our results?
  • Timebase delay – pre- and post-trigger location
  • Sequential timebase – capturing “just the facts”
  • Scope preferences we forget are available

Presenter: Stephen Murphy, Teledyne LeCroy Applications Engineer

Can’t attend live? Register anyway, and we will send you the recording and slides afterward.

Want to watch previous sessions?

Part One: Getting Your Oscilloscope Set Up Correctly
Part Two: Optimizing Your Display & Using Cursors and Measurements
Part Three: Getting Your Trigger to Do What You Want

Register for the rest of the series:
Part Five: Optimizing Your Vertical Gain
Part Six: Testing Noisy Power Supply Outputs

Register Here